Poly on sides and back. It is starting to sort of a slight shine

[TEG]

it shows a bit on just the sides. It is really not that much, but if you were looking at it closely you would see it. A casual observer might not even think anything of it, but of course, it bothers me. I can hide it by brushing my hair a certain way. I know it is because I wear a low density. I would rather not have to increase this.

Anyone know of a way to cover the shine a little bit?

 

[deg_dilemma]

Is it stuck down properly? Next time you bond, put a very thin layer of glue on the poly right up to the edge, so that you can be sure it's stuck down all the way.

 

[TEG]

Is it stuck down properly? Next time you bond, put a very thin layer of glue on the poly right up to the edge, so that you can be sure it's stuck down all the way.

yes, it is down properly. I did find a solution:: Toppik. Works very well!