Recent content by yomama69

Why don't you just put on an under helmet cap like this: https://www.amazon.com/Tough-Headwear-Sweat-Wicking-Helmet-Cooling/dp/B07CNKWBBK

But doesn't your tape turns into gel that runs into the hair system hair? That's what happens to me.

How can anyone get 3 weeks of hold? I just can't fathom that much hold time. I barely get to 2 weeks. Should you be kind enough to explain in detail your exact steps?

In what aspects does it make the hair much worse?

With my first hair system (0.03mm poly) I used super tape (around the entire perimeter), during a hot summer, sweat a lot and got around 12 days without any lifting at all (not even at the hairline). Then I switched to Walker signature tape and didn't notice any major difference until I started...

So, this is how I finally got rid of the liquefied tape from the hair system hair: I didn't have time to actually try any of the advice given above, so I just let be and carried on as if it weren't there. After 1 week the time came to wash my hair system, so I applied the Pro Hair Labs Shampoo...

Ok, thanks, I will try it. This idea of water flosser really intrigues me. I may buy it to try. By the way, isn't it harsh on your gums?

Thanks for a detailed advice. I agree with the oils causing V-loops to loss hair. However, how exactly should I go about removing the glue using only the isopropyl alcohol if I already have tried it and it didn't work?

Thanks. When it comes to the water flossers, have you tried that?

If Walker Rapid Release is the same as MHE Adhesive Remover, then yes, I can. Didn't it remove the hair colour after that soak?

Yes, poly bases are impermeable, of course, but this happened the way the tape started to seep through from under the base and into the hair and as I was sleeping I would then push the hair system hair onto the seeped through tape. Thanks for your advice but don't forget I already have the sytem...

Hello, I use 0.03mm poly unit, which I attach using Walker Signature tapes around the whole perimeter. The last time, I didn't have time to do the usual 2 week maintenance because of a trip and let the system sit on my head 3 more days than usual. Unfortunately, even these 3 extra days have...

I think that could work!

my local salon is 2 hours drive away and they don't do it

I actually think it will be very cost-effective. It's just I'm not just sure of the exact type of the polyurethane glue, any advice thereon anyone?